Case Studies
 Waterjet Cutting in the Aircraft Industry
A lengthy and complex project just left FedTech’s building, and it was a true test of our skill. The objective here was to cut 5.5" Haynes 282 rounds that were sent to us by a customer.
We were to process the rounds into the fuel injector pieces for a jet. The process is a little bit trickier than it sounds though, as each pound of this material is extremely expensive. Thus, it was a job in need of a careful hand and an even more careful procedure. Not only this, but the equipment that was attached to the rounds could not get water on them, so necessary precautions needed to be taken to ensure this equipment was properly protected.
 With skilled engineering and operating, we were able to successfully complete this project and meet every requirement the customer had given. The parts turned out very well, and will be used in the aircraft industry very soon.
Have an idea? Check out our Photo Album to see samples of our prior work in waterjet and laser cutting, to develop a better understanding of what FedTech is all about.
Now you can even check out some New Videos from our production floor too! If you have any questions about our capabilities in processing, feel free to Contact Us. Learn more about the waterjet cutting and laser cutting services that FedTech offers, or you can request a quote for your laser job shop needs!
|
